Ham Tech Prep

Home › Calculators › Decibel (dB) calculator

Decibel (dB) calculator

Three small calculators for the decibel math hams actually use: comparing two powers, converting watts and dBm, and following your power from the radio through the coax to the antenna.

1. Power ratio and dB

Enter two powers to get the change in dB, or a starting power and a dB change to get the new power.

W
W
dB
Try:
Change in dB
In plain terms
Formula

2. Watts and dBm

dBm is power compared with one milliwatt. Type either box.

W
dBm
Try:
Power
dBm
dBW (compared with 1 watt)

3. Gain and loss chain: from radio to radiated power

Start with the transmitter power, subtract the losses in dB, add the antenna gain in dB, then turn the total back into watts.

W
dB
dB

Enter losses as positive numbers. A handheld's rubber antenna can have negative gain; use ± for that.

Try:
Power reaching the antenna
Net gain of the system
ERP (compared with a dipole)
EIRP (compared with an isotropic antenna)
Formula

For the E9A02 repeater example, set 150 W, 2 dB, 2.2 dB and 7 dBd: the ERP comes out at 286 W.

What a decibel is

A decibel compares two powers on a logarithmic scale. The formula is dB = 10 × log10(P2 ÷ P1). Hams use it because it turns multiplying into adding: instead of saying the coax keeps 63 percent of the power and the antenna concentrates it 4 times, you say -2 dB and +6 dB, which add up to +4 dB.

Two rules cover most of what you will meet on the exam and on the air:

dBPower ratioExample from 10 W
+1 dB× 1.2612.6 W
+3 dB× 220 W
+6 dB× 440 W
+10 dB× 10100 W
+20 dB× 1001,000 W
-1 dB× 0.79 (20.6% lost)7.9 W
-3 dB× 0.55 W
-10 dB× 0.11 W

A 1 dB loss sounds small, but it throws away about a fifth of your power (G5B10). These rules are for power. Voltage ratios use 20 × log10 instead, which is why the formula on this page will not match a voltage calculation.

dBm, dBi and dBd

A letter after dB tells you the reference. dBm is compared with 1 milliwatt: 0 dBm is 1 mW, 30 dBm is 1 watt, 40 dBm is 10 watts and 50 dBm is 100 watts. Receiver specifications use it for tiny signals: -100 dBm is 0.1 picowatt (E4D14).

dBi compares an antenna with an isotropic antenna, an imaginary point that radiates equally in every direction. dBd compares it with a half-wave dipole. A dipole already has 2.15 dB of gain over isotropic, so the same antenna's gain in dBi is always 2.15 dB higher than in dBd (G9C04). That is why the chain calculator gives two answers: ERP uses the dipole reference and EIRP uses the isotropic one, and EIRP is always 1.64 times ERP.

Worked example: 50 watts, 2 dB of coax loss, a 6 dBi antenna

  1. Add up the dB: -2 dB for the coax and +6 dBi for the antenna gives +4 dB compared with an isotropic antenna.
  2. Coax first: 50 W × 10^(-2 ÷ 10) = 31.5 W reaches the antenna. The other 18.5 W warms the cable.
  3. EIRP: 50 W × 10^(4 ÷ 10) = about 126 W.
  4. ERP: 6 dBi is 3.85 dBd (E9A12), so the net is +1.85 dB over a dipole and 50 W becomes about 77 W.

Now swap in better coax with only 1 dB of loss: the EIRP rises to about 158 W. On VHF and UHF, where coax losses grow with frequency (T9B05), a better feed line can be worth as much as a bigger antenna.

Exam questions this calculator helps with

From the Technician T5 Electrical Principles topic, General G5 and G9, and Extra E9 Antennas and Transmission Lines. The formulas guide collects the rest of the exam math.

  1. T5B09 Which decibel value most closely represents a power increase from 5 watts to 10 watts?
    3 dB
  2. T5B10 Which decibel value most closely represents a power decrease from 12 watts to 3 watts?
    -6 dB
  3. T5B11 Which decibel value represents a power increase from 20 watts to 200 watts?
    10 dB
  4. G5B01 What dB change represents a factor of two increase or decrease in power?
    Approximately 3 dB
  5. G5B10 What percentage of power loss is equivalent to a loss of 1 dB?
    20.6 percent
  6. G4D05 How does a signal that reads 20 dB over S9 compare to one that reads S9 on a receiver, assuming a properly calibrated S meter?
    It is 100 times more powerful
  7. G9C04 How does antenna gain in dBi compare to gain stated in dBd for the same antenna?
    Gain in dBi is 2.15 dB higher
  8. E9A12 How much gain does an antenna have compared to a half-wavelength dipole if it has 6 dB gain over an isotropic radiator?
    3.85 dB
  9. E9A07 What is the effective isotropic radiated power (EIRP) of a repeater station with 200 watts transmitter power output, 2 dB feed line loss, 2.8 dB duplexer loss, 1.2 dB circulator loss, and 7 dBi antenna gain?
    252 watts
  10. E9A02 What is the effective radiated power (ERP) of a repeater station with 150 watts transmitter power output, 2 dB feed line loss, 2.2 dB duplexer loss, and 7 dBd antenna gain?
    286 watts
  11. E4D14 What power level does a receiver minimum discernible signal of -100 dBm represent?
    0.1 picowatts

More calculators