Home › Calculators › Antenna length calculator
Antenna length calculator
Enter a frequency in MHz to get a starting length for a half-wave dipole and a quarter-wave vertical or ground plane, in feet and inches and in meters.
The formulas: 468 and 234
A half-wave dipole is resonant when it is close to half a wavelength long. A full wavelength in meters is 300 divided by the frequency in MHz, so half a wavelength in free space works out to about 492 divided by the frequency, in feet.
A real wire antenna comes out a few percent shorter than that. The wire has thickness, and the ends are tied to insulators and rope, so the current behaves as if the antenna were slightly longer than it is. Hams call this end effect. Shaving about 5 percent off 492 gives the number found in almost every antenna book:
Dipole total length (feet) = 468 ÷ frequency (MHz)
Each dipole leg, or a quarter-wave vertical (feet) = 234 ÷ frequency (MHz)
In meters the same rules are about 142.6 ÷ MHz for the whole dipole and 71.3 ÷ MHz for each leg. A quarter-wave vertical is really half of a dipole standing on end: the radials, the car roof or the ground under it act as the missing half. That is why its element uses the same 234 rule as one dipole leg.
Why you still trim for SWR
The formulas assume a thin bare wire in open space. Your antenna is near the ground, a roof, trees and gutters, and it may use insulated wire, which slows the wave a little and makes the resonant length shorter. Each of these moves the best length by a few percent, so treat the number above as the length to start from.
- Cut each piece 3 to 5 percent longer than the calculator says, and fold the extra back on itself rather than cutting it off.
- Put the antenna up where it will live and check the SWR at several frequencies across the band.
- If the lowest SWR is below your target frequency, the antenna is too long: shorten it. Shortening a dipole raises its resonant frequency (exam question T9A05). If the lowest SWR is above your target, lengthen it.
- Trim both legs of a dipole by the same amount. On HF, change a few inches at a time; on 2 meters and 70 centimeters a quarter of an inch matters.
A quick way to estimate the trim: length scales with frequency. Say your 40 meter dipole shows its lowest SWR at 7.05 MHz and you want 7.20 MHz. Multiply the present length by 7.05 ÷ 7.20, about 0.979. For a dipole near 66.4 feet that is roughly 1.4 feet less in total, or a little over 8 inches off each leg.
Worked example: a 2 meter ground plane for 146.52 MHz
- Each leg or vertical element: 234 ÷ 146.52 = 1.60 feet. Times 12 is 19.2 inches, or about 0.49 meters.
- A full dipole would be 468 ÷ 146.52 = 3.19 feet in total, which is 3 feet 2.3 inches end to end, made of two legs of 19.2 inches each.
- That 19 inch figure is exactly the one the Technician pool asks about: a 19-inch vertical is common on 2 meters because it is a resonant quarter wave (T9A08).
On HF the same arithmetic gives much bigger numbers. At 7.2 MHz a dipole is 468 ÷ 7.2 = 65.0 feet, two legs of 32 feet 6 inches. At 28.4 MHz, in the Technician voice segment of 10 meters, it is 16.48 feet, two legs of about 8 feet 3 inches.
Before you put it up
Keep every part of the antenna far from power lines: if it falls, no part of it should be able to come within 10 feet of the wires (T0B06). A dipole radiates most strongly broadside to the wire (T9A10), so if you can choose, run the wire across the direction you most want to reach. For a ground plane, sloping the radials downward brings the feed point impedance close to 50 ohms (G9B02).
More background: antenna basics, coax and SWR and the formulas guide.
Exam questions this calculator helps with
From the Technician T9 Antennas and Feed Lines and T3 Radio Wave Propagation topics, and General G9 Antennas and Feed Lines:
- T9A08 Why is a 19-inch-long vertical antenna often used on 2 meters?
It is a resonant quarter-wave - T9A05 Which of the following increases the resonant frequency of a dipole antenna?
Shortening it - T9A04 What is a disadvantage of a handheld radio transceiver's short flexible antenna compared to a full-sized quarter-wave antenna?
It has low efficiency - T9A10 In which direction does a half-wave dipole antenna radiate the strongest signal?
Broadside to the antenna - T3B06 What is the formula for converting frequency to approximate wavelength in meters?
Wavelength in meters equals 300 divided by frequency in megahertz - T0B06 What is the minimum safe distance from a power line to allow when installing an antenna?
Enough so that if the antenna falls, no part of it can come within 10 feet of the power wires - G9B02 Which of the following is a common way to adjust the feed point impedance of an elevated quarter-wave ground-plane vertical antenna to be approximately 50 ohms?
Slope the radials downward - G9B03 Which of the following best describes the radiation pattern of a quarter-wave ground-plane vertical antenna?
Omnidirectional in azimuth