Ham Tech Prep

Technician › T9

T9 Antennas and Feed Lines

23 questions in the pool. Your exam will include 2, one from each group below.

Practice T9 now

T9A

Antennas: vertical and horizontal polarization, concept of antenna gain, definition and types of beam antennas, antenna loading, common portable and mobile antennas, relationships between resonant length and frequency, dipole pattern

T9A01

What is a beam antenna?

  1. A. An antenna built from square aluminum beams
  2. B. An omnidirectional antenna invented by Clarence Beam
  3. C. An antenna that concentrates signals in one direction
  4. D. An antenna that focuses the signal into two intense rays
Show the answer and explanation

Answer: C. An antenna that concentrates signals in one direction

A beam antenna is an antenna that concentrates signals in one direction. Like a flashlight focusing light, it sends more signal one way and less in others. The name has nothing to do with metal beams or an inventor.

Tip: Beam = signal aimed like a flashlight.

T9A02

Which of the following describes a type of antenna loading?

  1. A. Electrically lengthening by inserting inductors in radiating elements
  2. B. Inserting a resistor in the radiating portion of the antenna to make it resonant
  3. C. Installing a spring in the base of a mobile vertical antenna to make it more flexible
  4. D. Strengthening the radiating elements of a beam antenna to better resist wind damage
Show the answer and explanation

Answer: A. Electrically lengthening by inserting inductors in radiating elements

Antenna loading means electrically lengthening an antenna by inserting inductors (coils) in its radiating elements. This lets a physically short antenna act like a longer one and resonate at a lower frequency. A resistor would just waste power as heat.

Tip: Loading coil makes a short antenna act long.

T9A03

How is the polarization of an antenna described?

  1. A. By the shape of the driven element
  2. B. By the orientation of the electric field
  3. C. By the orientation of the magnetic field
  4. D. By the direction of radiation
Show the answer and explanation

Answer: B. By the orientation of the electric field

Polarization is described by the orientation of the electric field. If the electric field is vertical, the antenna is vertically polarized. For a simple wire antenna, this matches the direction the element points.

Tip: Polarization follows the Electric field.

T9A04

What is a disadvantage of a handheld radio transceiver's short flexible antenna compared to a full-sized quarter-wave antenna?

  1. A. It has low efficiency
  2. B. It transmits only circularly polarized signals
  3. C. It is more susceptible to receiver desensitization
  4. D. It only works on analog signals, not digital ones
Show the answer and explanation

Answer: A. It has low efficiency

A short flexible handheld antenna (often called a 'rubber duck') has low efficiency compared to a full-size quarter-wave antenna. Being shorter than ideal, it radiates less of the power. A full-size antenna will usually let you reach farther.

Tip: Rubber duck: handy but weak.

T9A05

Which of the following increases the resonant frequency of a dipole antenna?

  1. A. Lengthening it
  2. B. Inserting coils in series with radiating wires
  3. C. Shortening it
  4. D. Adding capacitive loading to the ends of the radiating wires
Show the answer and explanation

Answer: C. Shortening it

Shortening a dipole increases its resonant frequency. Shorter antennas resonate at higher frequencies, because higher frequencies have shorter wavelengths. Lengthening it or adding coils or capacitive end loading lowers the frequency.

Tip: Shorter wire, higher frequency.

T9A06

Which of the following types of antennas offers the greatest gain?

  1. A. 5/8 wave vertical
  2. B. Isotropic
  3. C. J pole
  4. D. Yagi
Show the answer and explanation

Answer: D. Yagi

A Yagi offers the greatest gain of these choices. It is a directional beam antenna that focuses signal in one direction. An isotropic antenna is the theoretical zero-gain reference, and verticals and J-poles have little gain by comparison.

Tip: Yagi = most gain on the list.

T9A07

What is a potential drawback of using a handheld VHF transceiver inside a vehicle that lacks an externally mounted antenna?

  1. A. Signal strength is reduced due to the shielding effect of the vehicle
  2. B. The bandwidth of the antenna will decrease, increasing SWR
  3. C. The SWR might decrease, decreasing the signal strength
  4. D. The handheld will overheat due to reflected power in the vehicle
Show the answer and explanation

Answer: A. Signal strength is reduced due to the shielding effect of the vehicle

Inside a vehicle, signal strength is reduced due to the shielding effect of the vehicle. The metal body blocks much of the signal going in and out. An external antenna avoids this problem.

Tip: A car's metal body blocks your handheld.

T9A08

Why is a 19-inch-long vertical antenna often used on 2 meters?

  1. A. It has high gain
  2. B. It is a resonant half-wave
  3. C. It is a resonant quarter-wave
  4. D. It has low RF radiation exposure
Show the answer and explanation

Answer: C. It is a resonant quarter-wave

A 19-inch vertical is a resonant quarter-wave on 2 meters. Quarter-wave feet = 234 / MHz, so 234 / 146 = 1.60 feet, and 1.60 x 12 = about 19.2 inches. A half wave would be about twice as long (about 38 inches).

Tip: 2 m quarter wave: about 19 inches.

T9A09

What is an advantage of a 5/8-wavelength whip antenna for VHF or UHF mobile service compared to a 1/4-wave antenna?

  1. A. It has more gain
  2. B. It radiates at a higher angle
  3. C. It has lower SWR
  4. D. It has lower impedance
Show the answer and explanation

Answer: A. It has more gain

A 5/8-wavelength whip has more gain than a 1/4-wave whip. It focuses more of the signal toward the horizon, which helps reach distant stations. It actually radiates at a lower angle, not higher.

Tip: 5/8 wave: more gain, lower angle.

T9A10

In which direction does a half-wave dipole antenna radiate the strongest signal?

  1. A. Equally in all directions
  2. B. Off the ends of the antenna
  3. C. In the direction of the feed line
  4. D. Broadside to the antenna
Show the answer and explanation

Answer: D. Broadside to the antenna

A half-wave dipole radiates most strongly broadside to the antenna, at right angles to the wire. Very little signal goes off the ends. So a dipole running east-west sends best to the north and south.

Tip: Dipole: strong broadside, weak off the ends.

T9A11

What is antenna gain?

  1. A. The additional power that is added to the transmitter power
  2. B. The additional power that is required in the antenna when transmitting on a higher frequency
  3. C. The increase in signal strength in a specified direction compared to a reference antenna
  4. D. The increase in impedance on receive or transmit compared to a reference antenna
Show the answer and explanation

Answer: C. The increase in signal strength in a specified direction compared to a reference antenna

Antenna gain is the increase in signal strength in a specified direction compared to a reference antenna. An antenna does not create extra power; it focuses the power it has into some directions. The reference is often an isotropic antenna or a dipole.

Tip: Gain = focusing, not more power.

T9B

Feed lines: types, attenuation vs frequency, selecting; SWR concepts; Antenna tuners (couplers); RF Connectors: selecting, weather protection

T9B01

Which of the following connectors should be carefully taped for weather protection when used outdoors?

  1. A. PL259
  2. B. BNC
  3. C. Type N
  4. D. All these choices are correct
Show the answer and explanation

Answer: D. All these choices are correct

All these choices are correct. PL-259, BNC, and Type N connectors can all let water in when used outdoors. Water in a connector causes loss and corrosion, so tape and seal them carefully.

Tip: Outdoors, every connector needs weatherproofing.

T9B02

What is the most common impedance of coaxial cables used in amateur radio?

  1. A. 8 ohms
  2. B. 50 ohms
  3. C. 600 ohms
  4. D. 12 ohms
Show the answer and explanation

Answer: B. 50 ohms

50 ohms is the most common impedance for coaxial cable in amateur radio. Most ham transceivers are designed for a 50-ohm load. 75-ohm coax is common for TV, but it is not one of the choices here.

Tip: Ham coax is 50 ohms.

T9B03

Why is coaxial cable the most common feed line for amateur radio antenna systems?

  1. A. It is easy to use and requires few special installation considerations
  2. B. It has less loss than any other type of feed line
  3. C. It can handle more power than any other type of feed line
  4. D. It is less expensive than any other type of feed line
Show the answer and explanation

Answer: A. It is easy to use and requires few special installation considerations

Coax is the most common feed line because it is easy to use and requires few special installation considerations. It can be run near metal and taped to towers without much trouble. It does not have the lowest loss of all feed lines, so that choice is wrong.

Tip: Coax wins on convenience.

T9B04

What is the major function of an antenna tuner (antenna coupler)?

  1. A. It matches the antenna system impedance to the transceiver's output impedance
  2. B. It helps a receiver automatically tune in weak stations
  3. C. It allows an antenna to be used on both transmit and receive
  4. D. It automatically selects the proper antenna for the frequency band being used
Show the answer and explanation

Answer: A. It matches the antenna system impedance to the transceiver's output impedance

An antenna tuner matches the antenna system impedance to the transceiver's output impedance. This lets the radio deliver power safely into an antenna system that isn't a perfect match. It does not tune in stations or pick antennas.

Tip: Tuner = impedance matchmaker.

T9B05

What happens as the frequency of a signal in coaxial cable is increased?

  1. A. The characteristic impedance decreases
  2. B. The loss decreases
  3. C. The characteristic impedance increases
  4. D. The loss increases
Show the answer and explanation

Answer: D. The loss increases

As frequency increases, the loss in coaxial cable increases. That is why low-loss cable matters more on VHF and UHF than on HF. The characteristic impedance stays the same as frequency changes.

Tip: Higher frequency, more coax loss.

T9B06

Which of the following connector types is most suitable as an RF connector for frequencies above 400 MHz?

  1. A. PL-259
  2. B. Type N
  3. C. RS-213
  4. D. DB-25
Show the answer and explanation

Answer: B. Type N

The Type N connector is most suitable above 400 MHz. It keeps a constant impedance and has low loss at high frequencies, and it is weather-resistant. The PL-259 works well at HF and lower VHF but is not ideal at UHF.

Tip: Above 400 MHz, choose Type N.

T9B07

Which of the following is true of PL-259 type coax connectors?

  1. A. They are preferred for microwave operation
  2. B. They are watertight
  3. C. They are commonly used at HF and VHF frequencies
  4. D. They are a bayonet-type connector
Show the answer and explanation

Answer: C. They are commonly used at HF and VHF frequencies

PL-259 connectors are commonly used at HF and VHF frequencies. They are not watertight, not ideal for microwaves, and they screw on rather than using a bayonet twist-lock (that is the BNC).

Tip: PL-259: the everyday HF/VHF plug.

T9B08

Which of the following is a source of loss in coaxial feed line?

  1. A. Water intrusion into coaxial connectors
  2. B. High SWR
  3. C. Multiple connectors in the line
  4. D. All these choices are correct
Show the answer and explanation

Answer: D. All these choices are correct

All these choices are correct. Water getting into connectors, high SWR, and many connectors in the line all add loss to a coax feed line. Fewer, well-sealed connectors and a good match keep loss down.

Tip: Water, mismatch, connectors: all add loss.

T9B09

What can cause erratic changes in SWR?

  1. A. Local thunderstorm
  2. B. Loose connection in the antenna or feed line
  3. C. Over-modulation
  4. D. Overload from a strong local station
Show the answer and explanation

Answer: B. Loose connection in the antenna or feed line

A loose connection in the antenna or feed line can cause erratic changes in SWR. As the connection moves or the wind blows, the match keeps changing. Check and tighten connectors when SWR jumps around.

Tip: Jumpy SWR? Look for a loose connection.

T9B10

What is the electrical difference between RG-58 and RG-213 coaxial cable?

  1. A. There is no significant difference between the two types
  2. B. RG-58 cable has two shields
  3. C. RG-213 cable has less loss at a given frequency
  4. D. RG-58 cable can handle higher power levels
Show the answer and explanation

Answer: C. RG-213 cable has less loss at a given frequency

RG-213 has less loss at a given frequency than RG-58. RG-213 is thicker, with a larger center conductor, so it also handles more power. RG-58 is thinner and lossier, though lighter and easier to handle.

Tip: Fatter coax (RG-213) = less loss.

T9B11

Which of the following types of feed line has the lowest loss?

  1. A. 50-ohm flexible coax
  2. B. Multi-conductor unbalanced cable
  3. C. Air-insulated hardline
  4. D. 75-ohm flexible coax
Show the answer and explanation

Answer: C. Air-insulated hardline

Air-insulated hardline has the lowest loss of these choices. Air wastes less energy than the plastic insulation in flexible coax, and the solid outer conductor helps too. It is more expensive and harder to install.

Tip: Air and hard pipe = lowest loss.

T9B12

What is standing wave ratio (SWR)?

  1. A. A measure of how well a load is matched to a transmission line
  2. B. The ratio of amplifier power output to input
  3. C. The transmitter efficiency ratio
  4. D. An indication of the quality of your station's ground connection
Show the answer and explanation

Answer: A. A measure of how well a load is matched to a transmission line

SWR is a measure of how well a load is matched to a transmission line. A 1:1 SWR means a perfect match, with no power reflected back. Higher SWR means a worse match.

Tip: SWR 1:1 = perfect match.

Practice T9 with scoring Take a 35-question practice exam